Schreiber Chillers MICRO MAX CHILLERS - Manual (Page 8)

8
A NOTE OF CAUTION: Always keep the fluid in the reservoir at its proper level. If
the unit condenser becomes clogged it must be cleaned. Be sure you check the condenser
often. Does not take much dirt in condenser to cause a problem.
The refrigeration system is a medium temperature. Never set the controller below 45
°F.
INSTALLATION
1. Place chiller on level ground.
2. Allow 3-in of clearance in the front and in the back of the unit. This clearance
is necessary for air circulation through to the unit. If the airflow in and out of
the chiller is restricted the chiller’s cooling capacity is reduced.
3. Connect chiller to power supply. Refer to the nameplate for electrical circuit
requirements.
4. Connect chilled water piping.
5. Fill tank with water to proper level at the fill port. Note the when the chiller is
started the water level will drop slightly as the pipes are filled. Add more
water after the unit is started.
OPERATION
1. After all electrical and plumbing connections are made, and the reservoir is filled,
You are ready to start the unit.
2. Turn the main power switch to the “ON” position.
3. The temperature displayed is the chiller discharge temperature. Refer to controller
page to modify the setting. Do not set the temperature less than 40 °F. You will
damage the unit.
3’ 3’