MoTeC SDC3 - Manual (Page 22)

MoTeC SDC3 20 Appendices
Receiving ECU Data
If present, the WRX V910 OEM ECU must be configured to transmit throttle position (and optionally manifold
pressure) to the SDC3 on the CAN bus.
A custom data set must be configured in ECU Manager under Adjust Æ General SetupÆCommunicationsÆSetup
Custom Data Sets . This data set must contain Throttle Position and Manifold Pressure as shown below:
To transmit the custom data set, one of the ECU CAN setup slots must be configured in ECU Manager as
‘Custom Data Set 1 Sequential’ on CAN ID 1040 under Adjust
Æ General SetupÆCommunicationsÆCAN Setup.