DE-STA-CO Precision Link Conveyors 1.5, 3.0, 4.5, 6.0 Table Top; 6.0, 9.0 Heavy Duty - Manual (Page 4)

WARNINGS AND CAUTIONS
Statements in this manual preceded by the words WARNING or CAUTION and printed in italics
are very important. We recommend you take special notice of these during service or repair.
WARNING: Means there is the possibility of personal injury to yourself or others.
CAUTION: Means there is the possibility of damage to the CAMCO unit.
SPARE PARTS KIT
CAMCO offers a Spare Parts Kit for all CAMCO Precision Link Conveyors. These kits include link
pin, needle bearings, followers, locknuts, shims and retaining rings required to rebuild (one) link
assembly. These are components that will most likely require replacement during repair of your
Conveyor. CAMCO recommends several Spare Parts Kits be purchased and kept on hand to
insure against “down time” in the event of damage to the link components.
Individual components may be purchased in any quantity by specifying the part numbers, as noted
in the Bill of Materials provided in this service manual.
BEFORE STARTING
Before starting disassembly of your CAMCO unit you should read and review the following instruc-
tions. These provide important information on parts and procedures necessary to successfully
complete your repair.
Comply with all Warnings and Cautions.
Read the “Trouble Shooting Guide” section of your “General Service Manual” before disassem-
bling CAMCO units. CAMCO recommends returning defective equipment for inspection and repair
whenever possible.
CAMCO uses Loctite to secure all screws and setscrews. If you encounter a fastener that is
difficult to remove, apply heat to the screw and remove while still warm.
3