BlueBird SG1314 - Manual (Page 19)

19
DANGER
Before servicing unit, wait for all moving parts to come to a complete stop. Turn engine off
and remove the spark plug wire.
Engine will not start 1. Be sure that the kill switch is turned on and the bail (Operator
Presence Control) is actuated against the handle.
2. Check to see that the bail fully actuates the push button switch
on the instrument panel.
3. Check all electrical wires for damage.
Belt coming off 1. Pulleys are not aligned.
2. Belt tension is insufficient. Adjust belt tension.
Belt glazed or slipping 1. Belt tension can be increased using the instructions provided
in this manual.
2. Limit depth of cut.
Pulley is not staying tight 1. Inspect shaft, pulley and key for damage. Be sure that set
screws are tightened properly.
2. Replace any damaged parts.
Cutting wheel is not rotating 1. Engine RPM is not sufficient to actuate centrifugal clutch. Be
sure that the throttle cable is fiunctioning properly.
2. Belt tension is insufficient. Adjust belt tension.
Cutting wheel continues to 1. Be sure that the throttle lever is moved to the disengage
rotate position.
2. Inspect throttle cable for damage.
3. Check to see that the throttCe cable is assembled to the
engine throttle correctly.
4. Engine RPM is not below 1,800 RPM which will disengage the
centrifugal clutch.
5. Centrifugal clutch is damaged and not disengaging properly.
Replace clutch.
Parking brake slips 1. Adjust brake tension per instructions in this manual.
2. Inspect brake cable and lever for damage.
3. Check to see if the brake pads are worn. Replace if
necessary.
TROUBLE SHOOTING GUIDE
Problem Possible Solutions