Avision DS320F (DF-0707S) - Manual (Page 41)

5-3
5.3 Replacing the ADF Snap-in Pad
Note: This section applies only to the product with an automatic document
feeder.
After scanning approximately 30,000 pages through the ADF, the pad may be
worn out and you may experience problems with document feeding. In this
case, it is highly recommended to replace the pad module with a new one. For
ordering the pad module, please consult your nearest dealer and follow the
procedure below to replace it.
Disassembling Procedure
1. Gently open the ADF front cover to the left.
2. Press both sides of the ADF snap-in pad inwardly with your fingers to pull
out the ADF snap-in pad from the slot.
Assembling Procedure
1. Take out the ADF pad module from the box.
2. Press both arms of the ADF snap-in pad module inwardly with your two
fingers.
3. Place it into the holes until it snaps into place.
ADF Pad