Avision AV3200C - Manual (Page 11)

2-4
Note: The factory setting for scanner is ID 6. Usually, ID
0 is assigned to an internal hard disk drive, and ID 7, ID
8 ,and ID 9 are not in actual use.
Using a suitable tool, turn the selector switch until
the arrow points to the desired ID number.
2.3 Setting SCSI Terminator
The scanner is equipped with a built-in terminator switch
on the rear of the
scanner. (See Figure 2-2).Turn the terminator switch on
if the scanner is to be
The scanner is equipped with a built-in terminator
switch on the rear of the scanner. (See Figure 2-
2) .Turn the terminator switch on if the scanner is to be
connected to the computer as the only or the last SCSI
device.Turn the terminator switch off if the scanner is to
be located between the computer and the other SCSI
device.