Autel Maxivideo MV400 - Manual (Page 11)

9
3. Installation and Connection
3.1 The Imager Head and Cable Installation
To use the tool, the imager head and cable must be connected to the
display unit. To connect the cable to the display unit, make sure the
key and slot (Fig. 4) are properly aligned. Once they are aligned,
finger-tighten the knurled knob to hold the connection firmly in
place.
Fig. 5
3.2 Accessories Installation
For MV400 (with 8.5mm imager head):
The three accessories include magnet, hook and mirror (Fig. 2). All
are attached to the imager head in the same manner. Hold the
accessory and the imager head as shown in Fig. 6. Slip the end of
the accessory over the imager head and then fix the accessory as
shown in Fig. 7.