Antex Electronics DMX8 USB Mixer - Manual (Page 3)

Safety Notices
Please read the following instructions and safety notices before installing this equipment.
Voltage Selection
Depending on the equipment you purchased it may be necessary to change the operating
voltage for your region. The power connector on the rear panel of the equipment may
have a voltage selection switch. Check the voltage setting and change if required. If no
voltage selection switch is available then the power supply is auto-sensing and you do not
need to select an operating voltage.
Warning This equipment is designed to operate while connected to a grounded
wall outlet. Always use a power cable with a properly grounded plug such as the
one provided with this equipment. To reduce the risk of electric shock, never
disable this important safety feature.
!
Canadian Deviations clause 1.1.1
All equipment installations are required to be in accordance with the Canadian Electrical
Code (CEC), Part 1, CAN/CSA C22.1
US Deviations clause 1.1.1
All equipment installations are required to be in accordance with the National Electrical
Code (NEC) ANSI/NFPA 70, and, unless marked or otherwise identified, the Standard for
the Protection of Electronic Computer/Data-Processing Equipment, ANSI/NFPA 75.
! Warning Only qualified technical service personnel should open the case of
this equipment. All user accessible connections and controls are located on the
front or rear panels of the equipment. Opening the case may also void your
warranty. If you need to make changes that require the case to be opened, contact
your authorized FTR service center.
iii