Antex Electronics DMX8 USB Mixer - Manual (Page 20)

c. Adjust these sliders so that when talking loudly into a microphone at a
distance of 12 inches or providing a line level signal of peak amplitude,
the meters light all bars including the occasional red bar at the top of the
scale. It is important to get this setting as high as possible with only
occasional indications of the red bar lighting.
Adjusting Monitor Channel Levels:
1. Use the Monitor Channel Buttons to select the monitor outputs for each input.
Each input can be mixed to any of the 4 monitor channel outputs. The
configuration of the Monitor Channel output may differ from the configuration of
the Recording Channels if required. This is useful in cases where teleconferencing
is required or where a public address system is in place and feedback needs to be
avoided.
2. For each monitoring channel adjust the Monitor Channel Level slider. Care
should be taken not to overdrive external equipment with these signals. Start by
setting these sliders 10dB lower than the average Recording Channel Level
setting, and connect to external equipment such as speakers, teleconferencing
system, or other devices. Adjust these sliders for each output to provide
appropriate volume levels at the external equipment.
Page 16