Antex Electronics DMX8 USB Mixer - Manual (Page 27)

Issue Steps to Correct
Hum or buzz in the recording. Usually caused by electrical interference to
the microphones or cables. Ensure all cables
and microphones are moved away from
possible sources of interference such as
computers, monitors, mixers and lighting.
If the problem persists disconnect all
microphone cables. Re-connect each
microphone cable until the buzz returns.
Replace the cable and/or microphone that
introduces the buzz.
Low recording level on one channel. Check and adjust the input and recording
levels using the DMX8 Configuration.
Check microphone placement.
Swap for a known good microphone. If the
problem persists swap for a known good
cable. If the problem persists contact your
vendor.
Low recording level on all channels. Check and adjust the input and recording
levels using the DMX8 Configuration.
Recording stops and the clock display
no longer increments. Check the USB cable is connected securely.
If it has become disconnected, the recording
program will need to be restarted.
Running FTR Reporter starts the
Settings Wizard unexpectedly FTR Reporter has detected a change in the
recording settings. This is most likely due to
not having the DMX8 USB Mixer powered
up before turning on the computer.
Exit the Settings Wizard, power up the
DMX8 USB Mixer then reboot the
computer.
Page 23