Total power solutions – Alpha Technologies AlphaGen DCX2000 - Quick Start Guide User Manual

Page 4

member of The Group

Alpha Technologies Alpha reserves the right to change specifications without notice.

Alpha is a registered trademark of Alpha Technologies.

041-135-B1-001 Rev A (07/2013)

For more information visit www.alpha.com

Alpha Technologies Inc.

3767 Alpha Way

Bellingham WA 98226

USA

Tel: +1 360 647 2360

Fax: +1 360 671 4936

Alpha Technologies Ltd.

7700 Riverfront Gate

Burnaby BC V5J 5M4

Canada

Tel: +1 604 436 5900

Fax: +1 604 436 1233

Alpha Technologies Europe Ltd.

Twyford House, Thorley

Bishop’s Stortford, Hertfordshire

CM22 7PA

United Kingdom

Tel: +44 1279 501110

Fax: +44 1279 659870

Alpha Technologies GmbH

Hansastrasse 8

D 91126 Schwabach

Germany

Tel: +49 9122 79889 0

Fax: +49 9122 79889 21

AlphaTec Ltd.

339 Saint Andrews Street

Suite 101 Andrea

Chambers

3307 Limassol

Cyprus

Tel: +357 25 375675

Fax: +357 25 359595

AlphaTEK ooo

Khokhlovskiy Pereulok 16

Stroenie 1 Office 403

109028 Moscow

Russia

Tel: +7 495 916 1854

Fax: +7 495 916 1349

Alpha Technologies

Suite 1903, Tower 1

33 Canton Road, Kowloon

Hong Kong City, China

Tel: +852 2736 8663

Fax: +852 2199 7988

Total Power Solutions

5.0 Storing Generator

Proper storage preparation will help prevent corrosion damage and help extend the life of the fuel system. Prior to

storage clean the generator entirely with a damp rag. To prevent fuel oxidizing, entirely drain the fuel system (see

Section 6). If this is not possible, fill the fuel tank entirely to reduce the air in the tank (air hastens fuel oxidation)

and ensure a quality gasoline stabilizer is used per the manufacturer's recommendations. It is also good practice to

change the oil before long term storage. Follow the procedure in Section 5 and the steps below.

1. Remove the spark plug and pour about a tablespoon of clean engine oil into the cylinder.
2. Crank the engine several times to distribute the oil.
3. Reinstall the spark plug.
4. Pull the starter grip until resistance is felt. This indicates the compression stroke and both the valves are closed.

Storing the engine in this state helps prevent internal corrosion.

Gasoline is highly flammable and explosive. You can be burned or otherwise seriously

injured improperly handling fuel. STOP the engine and let it fully cool before adding or

draining fuel. Remove all sources of ignition, heat, and spark from the immediate area.

Wipe up spills immediately.

WARNING! FIRE HAZARD

1. Turn the Engine Switch to the OFF position.
2. Attach a hose to the drain on the carburetor and route the hose into an approved gasoline container.
3. Turn the fuel valve to the ON position, and loosen the carburetor drain screw to drain the gasoline.
4. After the fuel tank has been drained, with the drain screw loosened, disconnect the spark plug wire and pull the

starter grip 3 to 4 times to clear the gasoline from the fuel pump.

5. Turn the fuel valve to the OFF position, and tighten the drain screw securely.
6. Pull the starter grip until resistance is felt. This indicates the compression stroke and both the valves are

closed. Storing the engine in this state helps prevent internal corrosion.

6.0 Draining Fuel