beautypg.com

Alpha Technologies AlphaGen DCX2000 - Quick Start Guide User Manual

Power

background image

041-135-B1-001 Rev. A

1

Power

DCX2000 3.0kW, 36VDC Portable Generator Quick Start Guide

The following instructions are intended to supplement the DCX2000 Operator’s Manual (Alpha P/N 041-135-B0). Read

and adhere to all safety instructions listed in the Operator’s Manual and this document. If you have any questions

regarding safe operation of the generator, consult the Operator’s Manual or contact Alpha Technical Support.

• Always check the engine oil level prior to operating the generator. Failure to do so could lead to

irreparable damage to the engine.

• Only use 86 octane fuel or higher with 10% Ethanol or 5% Methanol by volume.
• Only use this generator for DC applications, NOT for residential AC electrical appliances.

1.0 Connecting Generator

1.

Ensure the output breaker is OFF.

2.

Connect the power system to the generator

output cable (refer to section

3.0, Power System

Connections in the Operator's Manual for

connection options) connect the output cable to the

generator DC output connector, ensuring there is

no gap (see Figure 2).

Figure 1, Connecting the Power System to the Generator

Figure 3, Pushing the Engine Switch to ON Position

Figure 2, Fuel Valve ON While Pushing the Primer Bulb

3.

Turn the fuel valve to the ON position. If the fuel

tank was empty it may be necessary to pump the

primer bulb 7 times to get fuel to the carburetor.

• Carbon monoxide can KILL. Never run the the generator in an enclosed location.
• Electrical shock can KILL or severely injure. Do NOT make or break any connections

between the power system and generator while the generator is running. Turn the generator

OFF before disconnecting any cables or equipment.

WARNING! CARBON MONOXIDE & ELECTROCUTION HAZARD

4.

Push the engine switch on the control panel to the

ON position.

Note: When the power system is connected to the

generator and the circuit breaker is on, the LED

output (green) will be ON.

CAUTION!

Note: Ensure proper ground connection is made at

the generator.