Alpha Technologies AlphaGen ACX2000i 120V - Operator's Manual - Manual (Page 23)

23 041-036-B000-001, Rev. A (07/2013)
3.3 Changing Oil
Drain the oil while the engine is still warm to assure rapid and complete draining.
Make sure to turn the engine switch “OFF” before draining the oil.
CAUTION!
1. Remove the side maintenance cover.
2. Remove the oil dipstick.
3. Install the oil drain pipe (included with the generator).
4. Drain the dirty oil into a container. Be sure to allow time for the oil to drain completely.
5. Refill with the recommended oil, and check to be sure the oil level is at the upper line on the dipstick.
6. Reinstall the dipstick and then the maintenance cover and tighten the screws securely.
Recommended oil is SAE 15W-40 when ambient temperature is above 32° F (0° C).
Synthetic SAE 0W-40 is recommended if operating temperatures are below 32° F (0° C).
Engine oil capacity: 15.6 fl oz (460 ml)
Recommended Oil
SAE 0W-40 SAE 10W-40
0° F 32° F 113° F
(-18° C) (0° C) (45° C)
3.0 Maintenance
Dispose of used motor oil in a manner that is compatible with the environment and local disposal regulations.
ATTENTION:
Figure 3-2, Temperature Range and Oil Types
Figure 3-3, Changing Engine Oil
Upper Level
Dipstick
Oil Fill Hole
Lower Level
Oil Drain Pipe
Engine oil is HOT! Avoid contact with skin and clothing.
WARNING! BURN HAZARD