Alpha Technologies Te17 - Manual (Page 18)

T E 17 O UTDOOR E NCLOSURE A RGUS T ECHNOLOGIES
I NSTALLATION
4.2 Enclosure Disassembly
Some disassembly of the Te17 is possible for locations with limited access; e.g., narrow corridor. The en-
closure air conditioner and riser may be removed as follo
ws:
Figure 6–Ground cable connection to riser:
. Detach ground cable [a] from riser and push cable
Figure 7–Intrusion alarm connection from riser:
. Unplug connectors J13/P13 [a] to disconnect the
t
igure 8–Air conditioner connection, ground strap, door
. Unplug connectors J14/P14 to disconnect the air
4. rd from outlet and
5.
w and
7. weight of the front door.
CA
itioner must remain in an upright
riser (as required) per draw-
1
1a
2a
2b
3
4
5
6
8
3
4
5
6
8
1b
through access boot [b] to the enclosure section
above.
2
intrusion alarm and push cable through access boo
[b] to the riser section below.
F
wind stop and mounting bolts:
3
conditioner alarm cable wiring.
Unplug air conditioner power co
cut away tie-wraps from inside enclosure.
Detach enclosure ground strap from door.
6. Disconnect door wind stop by undoing scre
nut holding the arm to the door bracket. Once arm
is free, set into enclosure.
Be prepared to support the
8. Disassemble door by removing hinge nuts and
washers. Lift off door from enclosure.
UTION:
The air cond
position at all times
9. Detach enclosure from
ing 030-729-06 by removing four corner bolts.
P AGE 6 OF 14 030-729-C0 R EV A