Alera Lighting MDI, MDIA Wall Mount - Manual (Page 3)

© 2013 Alera Lighting, a division of Hubbell Lighting, Inc. Because of continuing product improvement programs, Alera Lighting reserves the right to change specifications
without notice. 701 Millennium Blvd. Greenville, SC 29607 / Tel 864.678.1000 / Website www.aleralighting.com
Page 3/3 Rev. 09/23/13 Beams / MDI, MDIA WM TID
MDI, MDIA WAll Mount
Technical Installation Data
1. Attach Top Mounting Brackets to the top of each
housing as shown using 8-32 screws provided.
2. Slide a Flanged Mounting Stud into each lower track
in each housing and one in each upper track on
Housing B. (6 total)
3. Insert Middle Light Seal halfway into one of the
Housings.
4. Butt Housing B against Housing A while engaging
Middle Light Seal and Top Mounting Brackets, and
electrically connecting in-row wiring.
5. Connect Top Mounting Brackets on top of each
housing using #8 screws and nuts provided and
tighten.
6. Attach each Bottom Light Seal to an Aligner using
the 8-18 × ¼ sheet metal screws provided using the
center hole in the seal.
7. Engage slots in each Aligner assembly with Flanged
Studs in lower track. Secure with #8 nuts provided
and tighten.
Housing B
Housing A
Top Light Seal
(2 Places)
Top Mounting Bracket
(4 Places)
Middle Light Seal
Bottom Light Seal (2 Places)
Aligner (2 Places)
8-18 × ¼ Screw
(2 Places)
8 × 32 Thread
Cutting Screw
(6 Places)
Mounting Nut & Washer
(6 Places)
Flanged Stud (6 Places)
6
7
connection inStructionS