Alera Lighting CVSL_CVPL - Arch Sensors - Manual (Page 2)

Page 2/2 Rev. 08/28/12 curves / CVSL CVPL arChiteCturaL SenSorS tiD
Curvista
installed architectural Sensors technical installation Data
© 2012 Alera Lighting, a division of Hubbell Lighting, Inc. Because of continuing product improvement programs, Alera Lighting reserves the right to change specifications
without notice. 701 Millennium Blvd. Greenville, SC 29607 / Tel 864.678.1000 / Website www.aleralighting.com
A
R
C
H
IT
E C T
U R A L S
E
N
S
O
R
S
Connection Instructions:
1. Install first fixture of row with two hangers.
2. Slide inner die cast plates together.
3. Secure fixture joints with two bolts and nuts
and attach hanger at opposite end.
4. Repeat steps 2 and 3 until row is complete.
5. At each end of the row, attach and align end
cap with two screws.
Suspension Instructions:
1. Set bottom nut to desired fixture height.
2. Adjust upper nut for a minimum of 3/8"
between upper and lower nuts.
3. Slide cable hanger into hanger slot.
4. Secure and tighten upper nut.
Cover Removal:
1. Rotate fasteners 90 degrees.
2. Lift and remove.