Alera Lighting CVL - Arch Sensors - Manual (Page 2)

Page 2/2 Rev. 08/28/12 curves / CVL ArChiteCturAL sensors tiD
Curv Louvered
installed Architectural sensors technical installation Data
© 2012 Alera Lighting, a division of Hubbell Lighting, Inc. Because of continuing product improvement programs, Alera Lighting reserves the right to change specifications
without notice. 701 Millennium Blvd. Greenville, SC 29607 / Tel 864.678.1000 / Website www.aleralighting.com
A
R
C
H
IT
E C T
U R A L S
E
N
S
O
R
S
Connection Instructions (2 Lamp):
1. Install first fixture of row with two hangers.
2. Slide inner die cast plates together.
3. Secure fixture joints with two bolts and nuts and
attach hanger at opposite end.
4. Repeat steps 2 and 3 until row is complete.
5. At each end of the row, attach and align end cap with
two screws.
Suspension Instructions (2 Lamp):
1. Set bottom nut to desired fixture height.
2. Adjust upper nut for a minimum of 3/8" between upper
and lower nuts.
3. Slide cable hanger into hanger slot.
4. Secure and tighten upper nut.
Connection Instructions (1 or 3 Lamp):
1. Install first fixture of row with two hangers.
2. Slide inner die cast plates together.
3. Secure fixture joints with two bolts and nuts and
attach hanger at opposite end.
4. Repeat steps 2 and 3 until row is complete.
5. At each end of the row, attach and align end cap with
two screws.
Suspension Instructions (1 or 3 Lamp):
1. Set bottom nut to desired fixture height.
2. Adjust upper nut for a minimum of 3/8" between upper
and lower nuts.
3. Slide cable hanger into hanger slot.
4. Secure and tighten upper nut.
18-7.1