Aeromotive 17143 - 96-98 1_2 4.6L DOHC COBRA A1000 FUEL SYSTEM - Manual (Page 9)

3-13. Starting from the fuel rails, plan a route to run an AN-08 supply line from each fuel rail to each side of the Y-block.
Cut the two supply lines to the determined length and install the AN-08 hose ends, as detailed in Section 4.
Note: Be sure to route all fuel lines clear of any moving suspension or drivetrain components and any exhaust
components! Protect fuel lines from abrasion and road obstructions or debris.
3-14. Using the above steel braided hose assemblies, connect one end to the Y-block and the other end to the fuel rails,
as shown in figure 3-1, and tighten.
3-15. Starting from the outlet of the fuel pump / filter assembly, plan a route to run an AN-08 supply line from fuel pump /
filter assembly to the Y-block, this line should be run along the same route you planned to run the return line in step
1.27. Cut the supply line to the determined length and install the AN-08 hose ends, as detailed in Section 4.
Note: Be sure to route all fuel lines clear of any moving suspension or drivetrain components and any exhaust
components! Protect fuel lines from abrasion and road obstructions or debris.
3-16. Using the above steel braided hose assembly, connect one end to the outlet of the fuel pump / filter assembly.
Keeping both the supply line and return line from the Aeromotive fuel tank together, secure both lines to the vehicle
along the predetermined route using the supplied tie-wraps. Once both lines are to their destination, the supply line to
the Y-block and the return line to the bottom of the regulator and tighten.
Note: Be sure to route all fuel lines clear of any moving suspension or drivetrain components and any exhaust
components! Protect fuel lines from abrasion and road obstructions or debris.
3-17. Once the regulator is installed, attach a suitable fuel pressure gauge (not supplied) to the 1/8 NPT port on the fuel
pressure regulator.