Aeromotive 17143 - 96-98 1_2 4.6L DOHC COBRA A1000 FUEL SYSTEM - Manual (Page 8)

3-7. Install two of the supplied AN-08 o-rings on the two supplied AN-08 90-degree Male Hose ends.
3-8. Using the above two AN-08 90-degree male hose ends and two standard AN-08 90-degree hose ends at the
regulator, plan a route to run an AN-08 supply line from the front of each fuel rail to each side of the regulator. Cut the
two supply lines to the determined length and install the AN-08 hose ends, as detailed in Section 4.
Note: Be sure to route all fuel lines clear of any moving suspension or drivetrain components and any exhaust
components! Protect fuel lines from abrasion and road obstructions or debris.
3-9. Using the above steel braided hose assemblies, connect one end to the side of the fuel pressure regulator and the
other end to the fuel rails and tighten.
3-10. In the vehicle’s engine compartment, find a suitable mounting location near the fuel rails for the supplied Y-Block,
using the Y-block as a template, mark the mounting holes and drill to accept a #10 screw.
3-11. Attach the Y-block to the vehicle using two #10 screws, nuts and lock washers.
3-12. Install two of the supplied AN-08 o-rings on the cutoff side of two AN-08 cutoff union fittings, if not already installed,
and install in each of the AN-08 ports located on the supplied Y-Block. Install one of the supplied AN-10 o-rings on the
cutoff side of the AN-10 to AN-08 reducer union fitting, if not already installed, and install in the AN-10 port located on
the supplied Y-Block.