Aeromotive 17156 - COBRA JET ENGINE KIT - Manual (Page 3)

20. With the bracket attached to the regulator, mount the bracket and regulator to the vehicle using two
#10 screws, nuts and lock washers.
21. Install one AN-10 o-ring on each of the two AN-10 to AN-08 union fittings (15610) and one AN-6 o-ring
on the AN-6 to AN-08 fitting (15649).
22. Thread the side of the AN-10 cutoff’s with the o-ring into each of the two AN-10 ports on the regulator.
Also do the same for the AN-6 cutoff fitting in the return port on the bottom of the regulator.
23. Install one AN-08 o-ring on each of the four AN-08 union fittings (15607).
24. Thread the o-ring side of one of the AN-08 cuttoff to AN-08 male flare into the front and rear of each
rail.