Aeromotive 17158 - COBRA JET COMPLETE FUEL SYSTEM - Manual

AEROMOTIVE
Part # 17158
05’- Present Mustang Race Fuel System Kit
INSTALLATION INSTRUCTIONS
CAUTION:
Installation of this product requires detailed knowledge of automotive systems and
repair procedures. We recommend that this installation be carried out by a qualified
automotive technician.
Installation of this product requires handling of gasoline. Ensure you are working in a
well ventilated area with an approved fire extinguisher nearby. Extinguish all open flames,
prohibit smoking and eliminate all sources of ignition in the area of the vehicle before
proceeding with the installation.
When installing this product, wear eye goggles and other safety apparel as needed to
protect yourself from debris and sprayed gasoline .
WARNING!
The fuel system is under pressure. Do not open the fuel system until the pressure has
been relieved. Refer to the appropriate vehicle service manual for the procedure and
precautions for relieving the fuel system pressure
.
Aeromotive system components are not legal for sale or use on emission controlled motor vehicles.
This kit contains the following parts:
1 ea fuel filter bracket (12305)
1 ea fuel filter (12321)
1ea p/n 14141 Ford 5.4L DOHC Fuel Rails
1ea p/n 13128 EFI Regulator
1ea p/n 15115 Ford Adapter Fuel Pressure Senor
1ea p/n 15102 Supply Adapter Tee Fitting
6ea p/n 15607 AN-08 To Cutoff AN-08 Union
5 ea p/n 15610 AN-08 to cutoff AN-10 union
1ea p/n 15631 Fuel Sample Valve
2 ea p/n 15645 AN-08 tank fitting
9ea p/n 15653 –8 Straight Hose End
3ea p/n 15654 -8 45-degree Hose End
13ea p/n 15655 –8 90-Degree Hose End
3ea p/n 15663 -8 180-Degree Hose End
1ea p/n 15649 AN-06 Cutoff To AN-08 Union
1ea p/n 15674 Y-Block 8-2x8
4 ea p/n 15685 AN-08 bulkhead fitting
12 ea cushioned hose clamps
12 ea self-drilling screw
3ea p/n 17704 Triple AN-08 Hose Separator
1 ea fuel cell (18667)
1ea Vacuum Tee
50ft –8 Black Nylon Braided Fuel Line
3ft 5/32” Vacuum Line
Section 1 - Fuel system installation, Chassis:
1-1. Once the engine has been allowed to cool, disconnect the negative battery cable and relieve the fuel system pressure.
1-2. Raise the vehicle and support it with jack stands.
1-3. Referring to the appropriate vehicle service manual for instructions, drain, disconnect any electrical and fuel
component connections and remove the OEM fuel tank. The removal of the vehicles drive shaft and exhaust system
may be necessary for fuel tank removal.
1-4. Once the OEM fuel tank has been removed, tie up all electrical connections and hoses that were disconnected.
1-5. Find a suitable place in the trunk to mount the fuel cell. For mounting use Aeromotive bracket P/N 18701, or call
Aeromotive. Pictured is a typical install of a fuel cell in a SN197, Figure 1-1.