Aeromotive 17202 - A2000 FUEL PUMP KIT - Manual (Page 9)

Thanks for purchasing another quality product designed, engineered and manufactured in Kansas City,
USA!
AEROMOTIVE, INC.
7805 Barton Street, Lenexa, KS 66214
913-647-7300 fax 913-647-7207
Section 4 – Final Checks and System Start-up
4-1. Ensure that any spilled gasoline and any gasoline soaked shop towels are cleaned up and removed from the
Evicinity of the vehicle!
4-2. Carefully lower the car onto the ground.
4-3. Fill the fuel tank with gasoline and check for any leaks in the system, if any leaks are found repair immediately.
CAUTION: While performing the following steps, if any fuel leaks are detected, immediately turn the ignition
OFF, remove any spilled fuel and repair the leak(s) before proceeding!
4-4. Reconnect the battery and turn the fuel pump ON WITHOUT starting the car. After several seconds, check the fuel
pressure. If there is no fuel pressure, turn the fuel pump OFF, wait one minute, turn the fuel pump ON, and recheck
the fuel pressure. Repeat this fuel pump OFF and ON procedure until the fuel pressure gauge registers fuel pressure.
4-5. With the fuel pressure gauge registering fuel system pressure, check for fuel leaks throughout the entire fuel
system! If any fuel leaks are found, turn the ignition and fuel pump OFF, remove any spilled fuel and repair
the leak before proceeding!
4-6. Once the fuel pressure gauge registers fuel system pressure and there are no fuel leaks, start the engine and adjust
the regulator to the desired fuel pressure.
4-7. Test drive the car to ensure proper operation and re-check the fuel system for leaks. If any leaks are found,
immediately discontinue use of the vehicle and repair the leak(s)!