Aeromotive 17202 - A2000 FUEL PUMP KIT - Manual (Page 2)

Section 1 - Fuel pump installation:
DO NOT RUN THE PUMP DRY! Excessive wear will result if the pump runs dry.
DO NOT DISASSEMBLE THE PUMP! Disassembly will throw the pump out of calibration and void all warranties on this
product.
1-1. Once the engine has been allowed to cool, disconnect the negative battery cable and relieve the fuel system
pressure.
1-2. Raise the vehicle and support it with jack stands.
1-3. Referring to the appropriate vehicle service manual for instructions, drain, disconnect any electrical and fuel
component connections, plug the open fuel line ends and remove the existing pump.
1-4. Find a suitable place on the vehicle chassis to mount the Aeromotive fuel pump. Make sure the location will
accommodate the pump mounting bolts, will position the pump lower than the fuel tank, is clear of the exhaust, is
clear of any moving suspension or drivetrain components and will keep the pump clear of road obstructions or debris.
1-5. Place one of the supplied AN-10 o-rings on the cutoff side of each of the four AN-10 cutoff unions.
1-6. Thread an AN-10 fitting with o-ring into each of the two sides of the fuel pump.
1-7. Thread an AN-10 fitting with o-ring into each side of the fuel filter.