Aeromotive 11102 - PRO SERIES FUEL PUMP - Manual (Page 3)

Thanks for purchasing another quality product designed, engineered and manufactured in Kansas City,
USA!
AEROMOTIVE, INC.
7805 Barton Street, Lenexa, KS 66214
913-647-7300 fax 913-647-7207
11. Attach a suitable fuel pressure gauge to the fuel system schrader valve, fuel rail or fuel pressure regulator.
12. Ensure that any spilled fuel and any fuel soaked shop towels are cleaned up and removed from the vicinity of
the vehicle!
CAUTION: While performing the following steps, if any fuel leaks are detected, immediately turn the ignition to
OFF, remove any spilled fuel and repair the leak(s) before proceeding!
13. Turn the ignition to ON without starting the engine , allow the pump to run for several seconds and check the fuel
pressure. If there is no pressure, turn the ignition to OFF, wait one minute, then turn the ignition to ON and recheck the
pressure. Repeat this ignition OFF and ON procedure until the gauge registers pressure or you detect a fuel leak. If no
pressure is registered on the gauge after running the pump for several seconds and you have found no leaks, check
all fuel and electrical connections to determine the cause.
14. Once the fuel pressure gauge registers pressure, start the engine. The fuel pressure gauge should register between
40 and 70 psi. If you have installed an adjustable fuel pressure regulator, adjust it to the desired setting.(For maximum
fuel system performance, we recommend using an Aeromotive adjustable fuel pressure regulator; call us for info.)
15. Shut the engine off. Using suitable clips and other mounting hardware, secure the newly installed fuel lines and
electrical wires by attaching them to the vehicle chassis.
16. Carefully lower the vehicle to the ground.
17. Test drive the vehicle to insure proper operation and re-check the fuel system for leaks. If any leaks are found,
immediately discontinue use of the vehicle and repair the leak(s)!