Aeromotive 11107 - BILLET HEX DRIVE FUEL PUMP - Manual

AEROMOTIVE Part # 11107
INSTALLATION INSTRUCTIONS
Not For Street Use!
CAUTION:
Installation of this product requires detailed knowledge of automotive systems and repair procedures. We
recommend that this installation be carried out by a qualified automotive technician.
Installation of this product requires handling of gasoline. Ensure you are working in a well ventilated area
with an approved fire extinguisher nearby. Extinguish all open flames, prohibit smoking and eliminate all sources
of ignition in the area of the vehicle before proceeding with the installation.
When installing this product, wear eye goggles and other safety apparel as needed to protect yourself
from debris and sprayed gasoline.
WARNING!
The fuel system is under pressure. Do not open the fuel system until the pressure has been relieved.
Refer to the appropriate vehicle service manual for the procedure and precautions for relieving the fuel system
pressure.
The enclosed Aeromotive fuel pump utilizes an o-ring sealed AN-10 style inlet and outlet ports; these ports are NOT PIPE
THREAD and utilize NO THREAD SEALANT.
A high capacity fuel filter must be installed between the fuel tank and pump inlet. We recommend an Aeromotive P/N
12302 or 12304. Call us for info.
To use this pump in your vehicle’s fuel system, we strongly recommend the following:
Gravity feed the pump by mounting it lower than the fuel cell.
Utilize AN-10 size high pressure fuel lines, fittings and o-rings for all connections from the
fuel cell to the engine.
Failure to follow the above recommendations may result in fuel leakage, bursting of the fuel lines, poor vehicle
performance and/or decreased fuel pump life! Improper installation will void all warranties for this product!
Performance Specifications: Model 11107
Fuel Compatibility Gasoline & Methyl Alcohol
Port Sizes Inlet & Outlet AN-10
Recommended Fuel Pressure regulator:
EFI
System Aeromotive p/n 13110
Carbureted System Aeromotive p/n 13202