Aeromotive 11102 - PRO SERIES FUEL PUMP - Manual

AEROMOTIVE Part # 11102
INSTALLATION INSTRUCTIONS
CAUTION:
Installation of this product requires detailed knowledge of automotive systems and repair
procedures. We recommend that this installation be carried out by a qualified automotive
technician.
Installation of this product requires handling of gasoline. Ensure you are working in a well
ventilated area with an approved fire extinguisher nearby. Extinguish all open flames, prohibit
smoking and eliminate all sources of ignition in the area of the vehicle before proceeding with the
installation.
When installing this product, wear eye goggles and other safety apparel as needed to
protect yourself from debris and sprayed gasoline.
WARNING!
The fuel system is under pressure. Do not open the fuel system until the pressure has
been relieved. Refer to the appropriate vehicle service manual for the procedure and precautions
for relieving the fuel system pressure.
The enclosed Aeromotive fuel pump utilizes an o-ring sealed AN-12 style inlet and outlet ports; these ports
are NOT PIPE THREAD and utilize NO THREAD SEALANT.
A high capacity fuel filter must be installed between the fuel tank and pump inlet. We recommend an
Aeromotive P/N 12302. Call us for info.
To use this pump in your vehicle’s fuel system, we strongly recommend the following:
Gravity feed the pump by mounting it lower than and as close as possible to the fuel tank.
If you are using a stock fuel tank, install a reservoir style sump in the bottom-rear of your fuel
tank. Exercise extreme caution and follow all manufacturer’s recommendations when
installing a reservoir style sump.
Utilize AN-12 size high pressure fuel lines, fittings and o-rings for all connections from the
fuel tank pickup to the fuel rails in the engine compartment.
Failure to follow the above recommendations may result in fuel leakage, bursting of the fuel lines, poor
vehicle performance and/or decreased fuel pump life! Improper installation will void all warranties for this
product!
Aeromotive system components are not legal for sale or use on emission controlled motor vehicles.
Specifications: Model 11102
Port Sizes Inlet & Outlet AN-12