Aeromotive 11110 - MARINE ELIMINATOR FUEL PUMP - Manual

11104 & 11110 Installation Instructions
WARNING!
The fuel system is under pressure. Do not open the fuel system until the pressure has been relieved.
Refer to the appropriate vehicle service manual for the procedure and precautions for relieving the fuel system
pressure.
To use this pump in your vehicle’s fuel system, you must do the following:
• A by-pass style fuel pressure regulator must be used in the system.
• Utilize AN-12 size high pressure fuel lines, fittings and o-rings for all connections from the fuel
tank pickup to the fuel pump.
• Mount pump level or lower and as close to the bottom of the tank as possible.
• Install a 12302 pre-filter and 12310 post filter.
• If you are using a stock fuel tank, install a reservoir sump in the bottom-rear of your fuel tank.
Exercise extreme caution and follow all manufacturers’ recommendations when installing a
reservoir sump. (Sump part # 15650)
• Tank/Fuel cell must have at least a ½” tank vent.
• If you choose not to install a reservoir sump, then you must install a high flow capacity fuel
tank pickup (3/4” inner tube diameter). (Installing pickup instead of a reservoir sump may
shorten the fuel pump life and cause drivability problems. When using a pickup, you should
maintain at least ½ tank of fuel in the vehicle at all times, to avoid possible engine & or fuel
pump damage.)
• For any street driving or continuous use, Aeromotive recommends the installation of a pump
voltage control module, Aeromotive p/n 16306 (not needed for marine use).
Failure to follow the above may result in fuel leakage, bursting of the fuel lines, poor vehicle
performance and/or decreased fuel pump life! Improper installation will void all warranties for this
product!
CAUTION:
Installation of this product requires detailed knowledge of automotive systems and repair procedures. We
recommend that this installation be carried out by a qualified automotive technician.
Installation of this product requires handling of gasoline. Ensure you are working in a well ventilated area
with an approved fire extinguisher nearby. Extinguish all open flames, prohibit smoking and eliminate all sources
of ignition in the area of the vehicle before proceeding with the installation.
When installing this product, wear eye goggles and other safety apparel as needed to protect yourself
from debris and sprayed gasoline.
The enclosed Aeromotive fuel pump utilizes an o-ring sealed AN-12 style inlet and an AN-10 style outlet port; these ports
are NOT PIPE THREAD and utilize NO THREAD SEALANT.