Aeromotive 11202 - A2000 CARBURETED FUEL PUMP - Manual

11202 INSTALLATION INSTRUCTIONS
WARNING!
The fuel system may be under pressure. Do not open the fuel system until any pressure has been
relieved.
The enclosed Aeromotive fuel pump utilizes an o-ring sealed AN-08 style by-pass port and o-ring sealed AN-10 style
inlet and outlet ports; these ports are NOT PIPE THREAD and utilize NO THREAD SEALANT.
This fuel pump is intended for LIMITED STREET USE or RACE applications, to use this pump in your vehicle’s fuel
system, we strongly recommend the following:
To use this pump in your vehicle’s fuel system, you must do the following:
• Utilize AN-10 size high pressure fuel lines, fittings and o-rings for all connections
from the fuel tank pickup to the fuel pump.
• Mount pump level or lower and as close to the bottom of the tank as possible.
• Install a 100 micron pre-filter and 10 micron post filter.
• If you are using a stock fuel tank, install a reservoir sump in the bottom-rear of
your fuel tank. Exercise extreme caution and follow all manufacturers’
recommendations when installing a reservoir sump. (Sump part # 15650)
• Tank/Fuel cell must have at least a ½” tank vent.
• For long term driving applications where continuous run times exceed 30 minutes
and fuel capacity is less then 10 gallons, Aeromotive recommends the installation
of a pump voltage control module, Aeromotive p/n 16306.
Failure to follow the above recommendations may result in fuel leakage, bursting of the fuel lines, poor vehicle
performance and/or decreased fuel pump life! Improper installation will void all warranties for this product!
Aeromotive system components are not legal for sale or use on emission controlled motor vehicles.
Pump Specifications:
Outlet pressure/flow 0 psi / 350 GPH
By-Pass Pressure 18 psi
Current Draw 10.5 amps @ 12 psi
CAUTION:
Installation of this product requires detailed knowledge of automotive systems and repair
procedures. We recommend that this installation be carried out by a qualified automotive technician.
Installation of this product requires handling of gasoline. Ensure you are working in a well ventilated
area with an approved fire extinguisher nearby. Extinguish all open flames, prohibit smoking and eliminate
all sources of ignition in the area of the vehicle before proceeding with the installation.