Aeromotive 11109 - IN-LINE ELECTRIC FUEL PUMP - Manual (Page 3)

Section 1 - Fuel system installation:
1-1. Once the engine has been allowed to cool, disconnect the negative battery cable and relieve the fuel system
pressure.
1-2. Raise the vehicle and support it with jack stands.
1-3. Referring to the appropriate vehicle service manual for instructions, drain, disconnect any electrical and fuel
component connections and remove the OEM fuel tank. The removal of the vehicles exhaust system may be
necessary for fuel tank removal.
1-4. Once the OEM fuel tank has been removed, remove the plastic fuel tank shield from the bottom of the tank.
1-5. Measure the position of the sump on the supplied Aeromotive fuel tank and mark the plastic fuel tank shield
accordingly. Using an ½” drill bit, drill the four corners of the sump cutout in the plastic fuel tank shield. Using a small
hand saw or reciprocating saw, cut out the remaining area from the plastic fuel tank shield. Once you have completed
this step your plastic fuel tank shield should look similar to Figure 1-1.
Figure 1-1
1-6. In the kit find two AN-10 cutoff union fittings and four of the AN-10 o-rings. Install each of the four o-rings on each end
of the two AN-10 cutoff union fittings.
1-7. Install each of the two AN-10 cutoff fittings into each end of the provided Aeromotive fuel pump, Aeromotive p/n
11101.
1-8. Noting the appropriate flow directions, install the provided fuel filter, Aeromotive p/n 12301, on the fuel pump outlet
and the other fuel filter, Aeromotive p/n 12304, on the fuel pump inlet. See figure 1-2.
Figure 1-2