Aeromotive 11213 - SS FUEL PUMP - ORB-08 - Manual (Page 2)

The following steps are typical of most installations:
1. Once the engine has been allowed to cool, disconnect the negative battery cable and relieve the fuel
system pressure.
2. Disconnect the existing pump fuel lines. Plug the open fuel line ends and remove the existing pump.
3. Find a suitable place on the vehicle chassis to mount the Aeromotive fuel pump. Make sure the
location will accommodate the pump mounting bolts, will position the pump lower than the fuel tank, is
clear of the exhaust, is clear of any moving suspension or drivetrain components and will keep the
pump clear of road obstructions or debris.
4. Making sure to mount the pump in the upright position and using the pump mounting bracket as a
template, mark and drill two mounting holes to accept ¼” bolts. Mount the pump bracket using two ¼”
bolts, nuts and lock washers. Slide the pump into the bracket and tighten the clamping bolt. Do not
over-tighten the clamping bolt. Doing so can permanently damage the pump motor!
Note: Be sure to route all fuel lines clear of any moving suspension or drivetrain components,
and any exhaust components! Protect fuel lines from abrasion and road obstructions or debris.
Typical “Dead-head” Style fuel system
Typical “Bypass” Style fuel system
AN-08 Inlet port
AN-08 Outlet port
Factory set outlet
pressure screw,
Do not adjust