Andrew James AJ000088 Bread Maker - Manual (Page 12)

12
Control Panel
Introduction of control panel.
The silkscreen may be subject to change without prior notice.
Starting the bread maker
As soon as the bread maker is plugged in you will hear a beeping noise. This
indicates that the bread maker is on and ready to use.

“1 3:00” will appear in the display screen.

The two dots in-between “3:00” will not flash constantly.

The back light will shine for approximately 20 seconds.

“1” in the display screen represents the default program setting, this is for
900g of dough at a “medium” default setting.
START/STOP BUTTON

This section will give instructions on how to pause, start and stop the
selected program.

To start a program, press the stop/start button once. A short beep and
the two dots will flash, signalling the program is beginning to start.

All other buttons are inactive during a program cycle, apart from the
stop/start button.

To stop the program press and hold the stop start button for more than
two seconds, a long beep will then signal the program has initiated the
close down procedure.