Spencer Vacuum Cleaning Systems - Manual (Page 9)

9
Notes:
1. Although three impellers and two deflectors are shown in this
typical drawing, the number, in each machine, will vary depen-
dent on the specific machine’s design criteria. To determine the
number of impellers and deflectors in a specific machine, con-
sult the factory. Be sure to include machine serial number and
appropriate impeller/deflector letter designation.
Screened items are recommended spare parts
1 - Motor and Shaft Assembly
2 - Division Head Packing
2A - Division Head Packing Plate
3
- Division Head (Not available as separate item)
4 - Rope Packing for Deflector
5 - End Head Bolts
6 - End Head
7 - Deflector (A,B, Etc.)
8 - Impellers (A,B, Etc.)
9 - Inter-Stage Deflector Packing
9A - Center Deflector Plates (normally not furnished on 30"
or smaller machines)
* Felt on Multi-stage Adjustable Discharge Type
10 - Split Clamped Hub or Tapered Bushing Clamp
(Part of Impeller assembly)
12 - End Head Gasket
13 - Feet
14 - Spacers
15 - Drive End Motor Bearing
16 - Casing
17 - Motor Base
18 - Motor Hold-Down Bolts
19 - Opposite Drive Motor Bearing
*
Typical Multi-Stage Standard Overhung Type (SOH)
2. When ordering replacement parts, refer to Section III.
Discharge
Intake