Imetec BELLISSIMA FLASH & GO PLUS - Manual (Page 47)

EN
87
EN
86
PROBLEMS AND SOLUTIONS
The appliance does not
go on
1. Make sure the adaptor (14) is inserted correctly into the power
supply connection (4).
2. Make sure the adaptor (14) is inserted into a wall socket.
No light is emitted when
the pulse activation
button (3) is pressed.
1. Make sure the ready-for-use LEDs (6) flash, which indicates
good contact with the skin and the surface treatment (5A or 15A) is
evenly and firmly pressed on the skin. OR
2. Check the skin colour check LEDs (6A): if they flash, the skin
tone is too dark for a safe application. Try to use the appliance on
another part of the body or contact the IMETEC service centre. OR
3. Check the lamp replacement LED (13): if it is on, replace the
lamp (5 or 15) by following the instructions in “Replacing the lamp”.
OR
4. Verify that the ready-for-use LEDs (6) are on.
If the ready-for-use LEDs (6) remain off after 10 seconds, switch
the appliance off and on again by pressing the switch-on/stand-by
button (10) twice.
If the problem persists, contact the IMETEC Customer Service
Centre. OR
5. Check the error/fault LED (7): if the LED us on, switch the
appliance off and on again by pressing the switch-on/stand-by
button (10) twice.
If the problem persists, contact the IMETEC Customer Service
Centre.
DISpOSAL
The packaging is made up of recyclable material. Dispose of it in
compliance with the environmental protection standards.
The appliance must be disposed of properly, in accordance with the
provisions of european standard 2002/96/EC.
The recyclable materials contained in the appliance must be
recovered so as to prevent environmental pollution.
For further information, contact the local disposal body or the
appliance dealer.
ASSISTANCE AND WARRANTY
To request repairs or purchase spare parts, please contact IMETEC’s
authorised customer service centre on the Toll-Free Number below or via the
website. The appliance is covered by the manufacturer’s warranty.
For details, read the attached warranty sheet. Failure to comply with the
instructions for use and maintenance provided in this manual will render the
manufacturer’s warranty null and void.
MI000937
0612 (MMYY)
Tel. +39.035.688.111 Fax +39.035.320.149