Imetec BELLISSIMA FLASH & GO PLUS - Manual (Page 42)

EN
77
EN
76
HAIR REMOVAL pROGRAM
A typical cycle of hair growth can take 18 to 24 months. During this time, more
sessions may be required to achieve permanent hair removal.
Hair removal efficacy varies from person to person and in different body parts,
according to the hair colour and level of tolerance of one’s own skin.
Recommended treatment plan in a complete hair growth cycle:
• Session 1 to 4: perform the sessions two weeks apart.
• Session 5 to 7: perform the sessions four weeks apart.
• The subsequent maintenance sessions can be performed from time to
time, when and if necessary, until long-lasting results are achieved.
Note:
The hair removal results will not be enhanced if the same part of the
body is treated more often than recommended (every two weeks).
Dormant hair follicles can be reactivated due to hormonal and physiological
changes. Therefore, occasional hair removal sessions may be required.
The individual reaction depends on the type of hair and biological factors that
may affect the growth cycle of hair. Some people can react quicker or slower
with regards to the recommended hair removal plan.
In any case, a long-lasting result cannot be expected with only one or two
sessions.
NOTE
The appliance is not effective on very light hair.
The appliance is not effective on natural white, grey, light blonde and red hair.
If your body hair is either of these colours, the appliance will not be effective.
INFORMATION BEFORE USE
POWER LEVEL
The appliance can be set to 5 power levels; 1 (lowest) to 5 (highest), indicated
by 3 power level LEDs (12).
SETTING THE POWER LEVEL
Press the power level setting buttons (+/-) (8):
“+” to increase the power level.
“-” to decrease the power level.
The power level LEDs (12) light up as follows according to the set power level:
Level 1 (lowest) - the left LED remains constantly on.
Level 2 - the left LED remains constantly on and the middle LED flashes.
Level 3 - the left LED and the middle LED remain constantly on.
Level 4 - the left LED and middle LED remain constantly on and the right LED
flashes.
Level 5 (highest) - all three LEDs remain constantly on.