Imetec BELLISSIMA FLASH & GO PLUS - Manual (Page 38)

EN
69
EN
68
Avoid exposure to the sun and/or tanning beds for 4 weeks before
using the appliance!
THE EYES
NEVER USE the appliance around or near the eyes.
The appliance can be used to remove hair in a delimited part of the face.
Special care must be taken to avoid the eyes when treating this area.
Keep away from the eyes!
Do not use the appliance your nipples or
genital organs (male or female).
OTHER pRECAUTIONS
FOR SAFE USE
BEFORE THE TREATMENT
THE POWER LEVEL
Select the power level CAREFULLY!
The power level refers to the intensity of the pulse of light that is projected
on the skin and ranges from the lowest to the highest. The power level LEDs
(12) indicate the set power level. When the power level increases, the results
improve, however, the risk of side effects also increases (refer to “Possible
side effects”).
Always start the treatment at the lowest power level!
Only if you feel a little or no discomfort with the power level set to the lowest,
can you increase the power by one level at the next session, and so on for
each subsequent hair removal session. For detailed instructions regarding
the power level, refer to “Power Level” in “Information before use”.
• Always shave the area that is to be treated and make sure the skin is
clean and dry before using the appliance.
• Cover any birthmark and tattoos before using the appliance.
• Cover dark brown or black spots, such as large freckles, a birthmark,
moles or warts before using the appliance.
• Never use flammable liquid, such as alcohol, products containing
alcohol (including perfume, sanitary products, etc.) or acetone to clean
the skin before using the appliance.
• Do not use the appliance on any part of the body where you may wish
hair to grow eventually.
THE pATCH TEST
It is recommended to perform a patch test before starting treatment, in
order to identify the maximum tolerance of your skin to light pulses. Refer to