Imetec BELLISSIMA ZERO - Manual (Page 43)

EN
83
EN
82
MAINTENANCE
CLEANING AND STORING
It is recommended to clean the appliance and the treatment surface (1A) after
each hair removal session:
• Disconnect the appliance from the power supply (7) before cleaning it.
• Clean the surface of the handpiece and the treatment surface (1A) gently,
with a dry, clean cloth.
• Store the appliance in a cool and dry place, away from heat and water.
ATTENTION:
Never immerse the appliance or any of its parts in water!
Never try to open or repair the appliance.
TROUBLESHOOTING
The appliance does
not go on
1. Make sure the plug (7) is inserted correctly into the power supply
connection (3).
2. Make sure the plug (7) is inserted into a wall socket.
No light is emitted
when the pulse
activation button (2) is
pressed
1. Make sure the skin colour/device-is-ready LED (5C) flashes, which
indicates good contact with the skin, and the surface treatment (1A)
is evenly and firmly pressed on the skin. OR
2. Verify the skin colour/device-is-ready LED (5C): if it flashes rapidly,
the skin tone is too dark for safe application. Try to use the appliance
on another part of the body or contact the IMETEC service centre. OR
3. Check the green power level LEDs (5B): a system error is present if
one or more power level LEDs (5B) flash while the skin colour/device-
is-ready orange LED (5C) remains off.
If the problem persists, contact the IMETEC Customer Service
Centre. OR
4. Verify whether the skin colour/device-is-ready orange LED (5C)
and the green power level LEDs (5A) are flashing all at once. If this
happens, disconnect the device from the power supply. The device
has completed its operational life cycle and must be disposed of
properly.
DISpOSAL
The product is packaged in recyclable materials. Dispose of it in
compliance with the environmental protection standards.
The appliance must be disposed of in compliance with EU standard
2002/96/EC.
The recyclable materials contained in the appliance must be collected
to prevent environmental pollution.
For further information contact the local waste authority or the
appliance retailer.