Imetec BELLISSIMA ZERO User Manual

Page 42

7. Set the lowest power level when applying the first treatment. Follow the

instructions in the “Information before use” chapter if you wish to use a

different power level for follow-up sessions.

8. Apply the treatment surface (1A) firmly on the skin. Only when the treatment

surface (1A) is entirely in contact with the skin, the skin colour/device-is-

ready LED (5C) starts to flash slowly.

9. Press the pulse activation button (2). The device immediately verifies the

skin colour: if the colour is light enough for safe application, the device emits

the light pulse on the skin accompanied by a sound, and the skin colour/

device-is-ready LED (5C) goes off. A slight tingling sensation may be felt.

Note: if the appliance does not emit a light pulse and the skin colour/

device-is-ready LED (5C) flashes rapidly, the skin tone is too dark for

safe application. Try to use the appliance on another part of the body.

10. Remove the treatment surface (1A) from the treated area.

11. A few seconds (depending on the power level set) after the previous

pulse is emitted, the skin colour/device-is-ready LED (5C) goes on again.

12. Select the application mode to continue the treatment.
By pulse Method

13A.Move the treatment surface (1A) to another section. Use the pressure

marks left previously to place the treatment surface on the adjacent section,

avoiding overlapped pulses (See “Covering the entire treatment area”).

14A.Repeat the process, starting from point 8, until the entire area to be

treated is covered.

Sliding Method

13B.Keep the pulse activation button (2) pressed and slide the device in a

slow gliding motion while remaining in contact with the skin, along the

area to be treated.

At lower power levels (1 and 2), the device takes only 1 to 1.5 seconds to

recharge between one pulse and another, thereby allowing an uninterrupted

sequence of flashes.

Make sure the entire area you intend to treat is covered while avoiding

to go over the same area a number of timed during the same session.

AFTER TREATMENT

15. Press the power level setting and on/off button (5A): all the LEDs will

flash sequentially.

16. Remember the power level used for the treatment session as this will be

reset when the appliance is next switched on.

17. Disconnect the adaptor cable (7) from the socket.
Caring for the skin after the hair removal session.

See “Other precautions for safe use”.