Other precautions for safe use – Imetec BELLISSIMA ZERO User Manual

Page 35

This applies to all types of skin and complexions, including those that do not

seem to tan quickly. The presence of large amounts of melanin, expose the

skin to greater risk when light epilation methods are used.

If you are using the device at power levels between 2 and 5, avoid

exposure to sunlight and/or tanning beds for 4 weeks before the

treatment!
You can continue to use the device after exposure to the sun only if

the power level is set to 1, which is the lowest.

The lowest power level of the appliance (level 1) is designed for safe

use even after exposure to the sun.
Exposure to the sun means constant unprotected direct exposure to sunlight

for more than 15 minutes or constant unprotected indirect exposure to

sunlight for more than 1 hour.

Always protect recently treated skin when exposed to the sun, making sure

to carefully spread sun cream SPF 30 or higher for 2 weeks after each hair

removal session.
THE EYES

NEVER USE the appliance around or near the eyes.

The appliance can be used to remove hair in a delimited part of the face.

Special care must be taken to avoid the eyes when treating this area.

Keep away from the eyes!

Do not use the appliance on your nipples or

genital organs (male or female).

OTHER pRECAUTIONS

FOR SAFE USE

BEFORE THE TREATMENT
THE pOWER LEVEL

Select the power level CAREFULLY!

The power level refers to the intensity of the pulse of light that is projected

on the skin and ranges from the lowest to the highest. The power level LEDs

(5B) indicate the set power level.

When the power level increases, the results improve, however, the risk of

side effects also increases (refer to “Possible side effects”).

Always start the treatment at the lowest power level!

Only if you feel little or no discomfort with the power level set to the lowest

can you increase the power by one level at the next session, and so on for

each subsequent hair removal session. For detailed instructions regarding

the power level, refer to “Power Level” in “Information before use”.