Extron Electronics MDA 4V SDI User Guide - Manual (Page 5)

MDA 4V SDI User's Guide • Introduction
MDA 4V SDI User's Guide
2 MDA 4V SDI User's Guide • Introduction 3
(2) 4-40 x 3/16" Screws
Use 2 mounting holes on
opposite corners.
VersaTools Rack Shelf
1/4 Rack Width False Front
Face Plate
DIS TR IB UT IO N A MP LIF IER
DIS TR IB UT IO N A MP LIF IER
DIS TR IBU TIO N A MP LIF IER
Figure 1 — Mounting the MDA on a VersaTools shelf
DIS TR IBU TIO N A MP LIF IER
DIS TR IBU TIO N A MP LIF IER
DIS TR IBU TIO N A MP LIF IE R
MD A S ER IES
DIS TRIB UTIO N A MPL IFIE R
Figure 2 — Mounting the MDA on a standard shelf
3 . Install false faceplate(s) or other unit(s) to the rack shelf.
Back of the rack mounting
The MDA can be mounted to the rear of a rack using the
Extron MBB 100 VersaTools back of the rack mounting kit
(part #70-367-01) (fi gure 3). The kit allows the product to be
vertically mounted to the front or rear rack supports and facing
towards either the front or the rear of the rack.
Figure 3 — Attaching the back of the rack kit
1 . Remove feet from the bottom of the MDA if they are
installed.
2 . Remove two screws from one side of the unit. Retain the
screws for possible later reassembly without the bracket.
3 . Attach one bracket to the side of the unit using the longer
screws included in the kit.
4 . Repeat steps 2 and 3 on the other side of the unit.
5 . Mount the unit to the rack using the two included rack
screws (fi gure 4, on the next page). The MDA can be
vertically mounted facing in either direction.
N Only VersaTools products and most IP Link products
can be mounted using the back of the rack mounting kit.