Extron Electronics MDA 4V SDI User Guide - Manual (Page 6)

MDA 4V SDI User's Guide • Introduction
MDA 4V SDI User's Guide
4 MDA 4V SDI User's Guide • Introduction 5
MA V SERIES AV MA TRIX SWITCHER I/O
AU D
AU DIO SE TU P
PR ES ET
VID
IR
+dB -dB
EN TER
2
7
6
5
2
4
1
INP UT S
OU TP UT S
8
3
1
8
6
5
4
3
7
Rear
Front
Figure 4 — Typical back of the rack installations
Furniture or projector mounting
Furniture mount or projector mount the MDA using the optional
MBU VersaTools under desk mounting kit (part #70-212-01)
or the PMK 100 VersaTools mini projector mounting kit
(part #70-217-01) as follows:
1 . Attach the mounting brackets to the MDA with the
provided machine screws (fi gure 5).
Ceiling
Digital Projector
Projector
Mounting
Bracket
M D A 4 V S D I
PO WER 1 5 V .5 A M A X
1 2
3 4
S D I IN P U T
S D I O U TP U TS
Mounting
Bolt
Projector Mounting
DIS TR IB UT IO N A MP LIF IE R
Under Desk Mounting
Figure 5 — Desk and projector mounting the MDA
2 . If feet were previously installed on the bottom of the MDA,
remove them.
3 . For furniture mounting, hold the MDA with the attached
brackets against the underside of the table or other
furniture. Mark the location of the screw holes of the
bracket on the mounting surface.
4 . For furniture mounting, drill 3/32" (2 mm) diameter pilot
holes, 1/4" (6.3 mm) deep in the mounting surface at the
marked screw locations.
5 . For furniture mounting, insert #8 wood screws into the
four pilot holes. Tighten each screw into the mounting
surface until just less than 1/4" of the screw protrudes.
6 . For furniture mounting, align the mounting screws with
the slots in the brackets and place the MDA against the
surface, with the screws through the bracket slots.
7 . For furniture mounting, slide the receiver slightly forward
or back, then tighten all four screws to secure the MDA.