beautypg.com

Connecting the ir 102 rx to a switcher, Connecting the receiver to a switcher, Installaton and operaton, cont’d – Extron Electronics IR 102 Kit User Manual

Page 8: Connectng the ir 102 rx to a swtcher

background image

IR 102 Remote Control Kit • Installation and Operation

Installaton and Operaton, cont’d

1-6

IR 102 Remote Control Kit • Installation and Operation

1-7

N

On the side mounting plates, devices are typically

mounted on the outside of the bracket. On the front

mounting plate, devices are typically mounted on the

inside of the bracket.

N

The front mounting plate is 1/4" taller than the side

plates. This size helps ensure the accessibility of buttons

or connectors.

3.

Affix the black rubber pad to the mounting plate.

4.

Place the U-bolt around the ceiling pole and insert the two

legs of the U-bolt through the slotted holes on the bracket’s

mounting plate and then through the slotted holes on the

backing brace.

For a typical (1.5" to 2.0" diameter) pole

— The supplied

U-bolt fits a typical ceiling pole.

For a smaller or larger pole

— Locally obtain a U-bolt that

fits the ceiling pole. The slotted holes on the bracket will

accommodate a U-bolt for pole sizes from 1.0" to 2.5" in

diameter.

5.

Secure the bracket to the U-bolt with the included hex

nuts, washers, and lock washers.

The IR 102 Rx can also be mounted using other kits, as shown

below.

Extron
PMK 350

Low Profile Two-product
Projector Mounting Kit

Extron

Power Supply

Plastic Tie

Extron
IR 102 Rx

Cover Sheet

Front Plate

Rear Plate

Rubber Pad

U-bolt

Projector mounting the IR 102 Rx with the PMK 350
kit, part #70-563-02 or #70-563-03

Connectng the IR 102 Rx to a Swtcher

1.

Power down the switcher.

2.

Connect the IR 102 Rx to the switcher via the RS-232 or

contact closure ports, available on both 9-pin and captive

screw connectors.

3.

Position the IR sensor at the best location for the IR 102

handheld remote control.

4.

Connect the IR Sensor to the IR In connector on the Remote

Receiver.

5.

Connect the external power supply to the Remote Receiver,

then plug one end of a standard IEC power cord into

the power supply and the other end into a 100-240 VAC,

50/60 Hz power source.

6.

Power up the switcher.