John Wood Takagi - 240H-340H-540H - Manual (Page 38)

38
Page
ADDITIONAL FEATURES
You can get some information about the water heater condition by pressing the "INFO" button. For more
information follow the procedures below:
The remote controller has a function that can change units of temperature and flow rate from °F to °C and
from gallon per minute to liter per minute and vice versa, please follow the procedures below:
Normal Operation
Owner's Guide
-Unit conversion mode-
Operation
Screen on the controller
Temperature controller Remote controller
1.
Press the "ON/OFF" button on the controller in
order to turn the controller on.
2. When ON, the orange LED is lit.
3.
The previous set temperature will be displayed on
the screen.
4. Press the "INFO" buttons for at least 3 seconds.
5.
The set temperature should now be displayed in the
alternate unit of measurement.
(EX.: 100 °F)
(EX.: 38 °C)
Operation
Screen on the controller
Temperature controller Remote controller
1.
First of all, inlet water temperature will be displayed
on the controller by pressing the "INFO" button.
2.
Outlet water temperature will be displayed on the
controller by pressing the "INFO" button.
3.
And then, water flow will be displayed on the
controller by pressing the "INFO" button.
4. Press the "INFO" button to finish information mode.
Inlet water temperature
(EX.: 16 °C)
Outlet water temperature
(EX.: 50 °C)
Water flow
(EX.: 13.0 LPM)
When the water heater is connected with the remote controller, the temperature
controller will not operate temperature settings, as only work for the information
mode.
-Information mode-