Xylem Expert 800-900 - Manual (Page 14)

Manual
GB Manual Expert Log 800-900.doc
14
To reset a sensor to its factory setting, click Set Factory Zero respectively.
To update the pressure values displayed, click Read Act Value(s).
Options
Configuration
General:
Setting the program language, activation/deactivation of auto detection of existing serial ports
(changes will take place only upon program restart), and showing/hiding the picture.
Units:
The number of decimal places for the predefined units of pressure, temperature and length is specified
here. In addition one user-defined pressure and length unit each can be specified, with details about
conversion factors and decimal places.
Channel-Names:
The user can customize the descriptions of individual channels as per his requirements.
Modem:
This page is needed for specification of a telephone number and additional initialization commands.
The information entered under General, Units and Channel Names is reflected throughout the
Expert Log Link program!
Modem
Connecting: Connect to a modem by dialing the previously recorded telephone number and
initialization commands
Disconnecting: Disconnect from the modem
Info
Information about the software version and contact details for the company MJK is displayed.
Clicking OK causes the values specified in the WriterWL to be updated and the configuration screen to
be exited. CANCEL causes return to the main program without saving any changes.