YSI IQ SensorNet MIQ/R6 Module - Manual (Page 9)

MIQ/R6 Installation
3 - 1 ba76031e01 01/2012
3 Installation
3.1 Scope of delivery
The scope of delivery of the MIQ/R6 is listed in the I NSTALLATION
chapter of the system operating manual.
3.2 Installation in the IQ S ENSOR N ET
The IQ S ENSOR N ET provides a number of options for integrating the
MIQ/R6 mechanically and electrically in the system (stacked mounting,
distributed mounting, etc.). The various types of installation are
described in detail in the I
NSTALLATION chapter of the system operating
manual.
3.2.1 Software requirements IQ S ENSOR N ET
Software requirements for the use of the Cleaning function:
 Controller: from version 2.20 up
If you use a terminal with a software version from 2.20 up, the Clean
display flashes. If you use an MIQ/T2020 terminal with a software
version lower than 2.20, the Clean display does not appear.
The measured value display of the sensor flashes.
Note
It is possible to update the software if your components have older
software versions. Please contact YSI.