YSI AmmoLyt Plus 700 IQ - Manual (Page 20)

Commissioning AmmoLyt
®Plus
700 IQ
3 - 8 ba76003e01 01/2012
Are the plug
connections dry?
Before connecting the sensor and sensor connection cable, make sure
that the plug connections are dry. If moisture gets into the plug
connections, first dry the plug connections (dab them dry or blow them
dry using compressed air).
Connecting the sensor
to the sensor
connection cable
Fig. 3-5 Connect the sensor
1 Take the protective caps off the plug connections of the sensor
and the SACIQ sensor connection cable, and keep them safe.
2 Plug the socket of the SACIQ sensor connection cable onto the
plug head connector of the sensor. At the same time, rotate the
socket so that the pin in the plug head connector (1) clicks into
one of the two holes in the socket.
3 Then screw the coupling ring (2) of the sensor connection
cable onto the sensor up to the stop.
SACIQ
1
2