YSI AmmoLyt Plus 700 IQ - Manual (Page 19)

AmmoLyt
®Plus
700 IQ Commissioning
3 - 7 ba76003e01 01/2012
Mounting the standard
protective hood
Fig. 3-4 Mounting the standard protective hood.
Cleaning the protective
hood
The coupling ring of the protective hood can be taken apart for cleaning
purposes (see section 6.2 E
XTERIOR CLEANING ).
3.4.3 Connecting the sensor to the IQ S ENSOR N ET
Connection cable The SACIQ sensor connection cable is required to connect the sensor.
Information on this and other IQ S
ENSOR N ET accessories is given in
the YSI catalog and on the Internet.
Note
Do not suspend the sensor on the sensor connection cable. Use an
armature or electrode holder. Information on this and other IQ S
ENSOR
N ET accessories is given in the YSI catalog and on the Internet.
Note
How to connect the SACIQ sensor connection cable to the
IQ S
ENSOR N ET is described in chapter 3 I NSTALLATION of the
IQ S ENSOR N ET system operating manual.
1 Loosen the coupling ring (1) of the protective hood.
2 Push the protective hood on the sensor as far as it will go.
3 Tighten the coupling ring of the protective hood.
1