Xylem handylab pH 11 - Manual (Page 32)

Operation handylab pH 11
32 ba75366e04 01/2011
4.4 Configuration
You can adapt the measuring instrument to your individual requirements. To
do this, the following parameters can be changed (the status on delivery is
marked in bold):
Note
You can leave the configuration menu at any time with . The parameters
that have already been changed are stored.
Display during the
pH calibration
Display during the
pH calibration Buffer nominal value, or current
electrode voltage
pH resolution 0.01 or 0.001
1 Switch off the measuring instrument.
2 Press the key and hold it down.
3 Press the key.
The display test appears briefly on the display. CAL diSP ap-
pears on the display.
4 Select the required display during the pH calibration with
<
▲> <▼>.
mV: Display of the current electrode voltage
/pH: Display of the buffer nominal value.
5 Confirm with .
The measuring instrument automatically switches to the pH
measuring mode.