Xylem CG 853P - Manual (Page 44)

Operation
120
Note
The
AutoStore function is interrupted if you perform other
functions, e.g. output data storage.
After completing the other function, the
AutoStore function
continues. However, as a result, gaps can occur in the
recording of the measured values.
5 As soon as all 200 memory locations are full, the Au-
toStore function is terminated (Int 1 = OFF).
If too few storage locations are available for your
measurements:
– backup the data storage (see page 121) and
– clear the data stored (see page 127).
6 Confirm with .
The prompt for the I.D. number appears on the dis-
play.
7 Press < ▲ > < ▼ > to set the required I.D. number.
8 Confirm with .
The instrument changes to the measuring mode and
starts the measuring and storage procedure.
AutoStore flashes on the display.