Xoro HSD 7580 - Manual (Page 58)

6
Engl
ish
SAFETY INFORMATION
Operation and Position
1.
During playback, the disc rotates very fast. Do not open or do not move the player
during playback. Otherwise the disc can be damaged.
2. Do not connect accessories on the player which are not defined by the manufacture.
3. Do not place this product on an unstable cart, stand, tripod, bracket, or table. The
product may fall, causing serious injury to a child or adult, and serious damage to
the product. Use only with a cart, stand, tripod, bracket, or table recommended by
the manufacturer, or sold with the product. Any mounting of the product should fol-
low the manufacturer's instructions, and should use a mounting accessory recom-
mended by the manufacturer.
4. A product and cart combination should be moved with care. Quick stops, excessive
force, and uneven surfaces may cause the product and cart combination to overturn.
5. The player is able to show a still image on the TV screen or monitor over an unlim-
ited period of time. This can cause damage to the screen. It is therefore advisable to
activate the screen saver. Or switch the player off, if the device is not in use.
6. Do not uses the player permanent in the 4:3 mode. This can cause damage to the
screen.
7. Do not increase the volume when the player is just playing very quiet sections. This
cold damage the speaker if very loud passages starts all of a sudden after the quiet
section.
8. Place only CDs or DVDs into the tray.
9. Switch the player off by the Off/On switch if it is not going to used for a longer period
of time.
10. Disconnect the main plug during thunderstorms.
11. Slots and openings in the cabinet are provided for ventilation and to ensure reliable
operation of the product and to protect it from overheating, and these openings must
not be blocked or covered.
12. The openings should never be blocked by placing the product on a bed, sofa, rug, or
other similar surface.
13. This product should not be placed in a built-in installation such as a bookcase or
rack unless proper ventilation is provided or the manufacturer's instructions have
been adhered to.
14. Protect the device against weather influences, moistures and high temperature.
15. Never spill liquid of any kind on the product.
16. Do not expose the device and the remote control to direct sunlight.
17. If an outside antenna or cable system is connected to the product, be sure the an-
tenna or cable system is grounded so as to provide some protection against voltage
surges and built-up static charges. Article 810 of the National Electrical Code, ANSI/
NFPA 70, provides information with regard to proper grounding of the mast and
supporting structure, grounding of the lead-in wire to an antenna discharge unit, size
or grounding conductors, location of antenna-discharge unit, connection to ground-
ing electrodes, and requirements for the grounding electrode.