Xoro HSD 8420 - Manual (Page 42)

6
English
BASIC CONNECTIONS
Connecting to a TV set by YUV (Component RCA)
The TV set with Y, Cb, Cr input can get more clear picture and realistic image when it
connects to Y, Cb, Cr output jacks of this player. The Video out setting must be set as
Compoment if you use Y, Cb, Cr output, so 480i or 576i are available.
Notes:
1.
Choose below speaker setting in the Audio menu if you use the TV speaker.
•
Front: Large
•
Center/Rear/Subwoofer: OFF
At this setting situation which is Stereo effect, the signal from Audio output LT, RT is
the same as the FL, FR output, also the same as the audio signal from Scart jack.
You could also conntect the Stereo output (LT/RT) to an Audio system.
2. Only one kind of connection to the TV set can be made. If your TV set does not
support Y Pb Pr function, do not switch the VIDEO OUT to Y Pb Pr of the unit,
otherwise there will be no picture output.
3. If the your TV set support Progressive Scan, than you should choose in the Video
Setup the option P-Scan by the Video-Out” settings.
Connecting to a TV by S-Video or CVBS
If the TV has S-Video input, than you can connect the DVD player with an S-Video cable.
For getting sound, please connect the Red and White wire from the AV cable with the TV
set. If the TV support only Video (CVBS) in, than connect the AV cable with the TV by using
the yellow wire boor the video signals and the RE and White wire for Audio signals.